OCCUPANT DETECTION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the occupant detection sensor removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front seat assembly (Only for removal and installation)

  • Front seatback frame sub-assembly (Including removal and installation)

  • Front seat adjuster assembly (Including removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B004CCI

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  3. REMOVE FRONT SEAT CUSHION SHIELD RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  4. REMOVE FRONT INNER SEAT CUSHION SHIELD RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  5. REMOVE LIMIT SWITCH ASSEMBLY

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD (for Standard Seat Type)


    1. B004ANW

      Disconnect the connector.

    2. w/ Seat Heater System:


      1. B004AVB

        Disconnect the connector.

      2. Detach the wire harness clamp.

    3. Detach the hooks.

      B004B6V
    4. B004A39C01
      B004CG0 Protective Tape

      Using a thin-bladed screwdriver, detach the claw and remove the connector of the occupant detection sensor.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

    5. B004AHLC02
      B004B1M Remove in this Direction

      Remove the separate type front seat cushion cover with pad.

  8. REMOVE FRONT SEAT CUSHION PAD WITH COVER RH (OCCUPANT DETECTION SENSOR) (for Sports Seat Type)

    Tech Tips


    • The occupant detection sensor cannot be removed from the front seat cushion pad with cover RH as they are a unit.

    • Use the same procedure described for the separate type front seat cushion cover with pad.

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) (for Standard Seat Type)

    Tech Tips

    The occupant detection sensor cannot be removed from the separate type front seat cushion pad as they are a unit.


    1. Using a thin-bladed screwdriver, detach the hooks and remove the separate type front seat cushion pad(occupant detection sensor) from the separate type front seat cushion cover as shown in the illustration.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

      B004A8MC02
      B004CG0 Protective Tape - -