SEAT BELT WARNING LIGHT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the telltale light assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system	Click here
		Pre-collision system	Click here
		Parking assist monitor system	Click here
	Steering sensor zero point calibration	Variable gear ratio steering system	Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

Click here
REMOVE NO. 2 DECK BOARD

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative(-) auxiliary battery terminal to disable the SRS system.
  
  Click here
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE MULTI-DISPLAY

Click here
REMOVE TELLTALE LIGHT ASSEMBLY
1. Remove in this Direction
  
  Using moulding remover A, push in the direction indicated by the arrow shown in the illustration to detach the claws and remove the telltale light assembly.