LIMIT SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the limit switch assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front seat assembly LH (Only for removal and installation)

  • Front seat assembly RH (Only for removal and installation)

  • Front seatback frame sub-assembly LH (Including removal and installation)

  • Front seatback frame sub-assembly RH (Including removal and installation)

  • Front seat adjuster assembly LH (Including removal and installation)

  • Front seat adjuster assembly RH (Including removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B004CCI

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  3. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  4. REMOVE LIMIT SWITCH ASSEMBLY (for Outer Side)


    1. B004C8ZC01
      B004C4F Connector
      B004ANI Screw
      B004B1M Remove in this Direction

      Disconnect the connector.

    2. Remove the 2 screws.

    3. Pull in the removal direction shown in the illustration to detach the guides and remove the limit switch assembly.

  5. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

    Click here

  6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  7. REMOVE SEAT ADJUSTER COVER CAP LH

    Click here

  8. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH

    Click here

  9. REMOVE FRONT SEATBACK SUB-ASSEMBLY LH (for Standard Seat Type)

    Click here

  10. REMOVE FRONT SEAT HEADREST SUPPORT (for Standard Seat Type)

    Click here

  11. REMOVE FRONT SEAT HEADREST SUPPORT (for Sports Seat Type)

    Click here

  12. REMOVE FRONT UPPER SEATBACK COVER SUB-ASSEMBLY LH (for Standard Seat Type)

    Click here

  13. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Standard Seat Type)

    Click here

  14. REMOVE FRONT SEATBACK PAD WITH COVER LH (for Sports Seat Type)

    Click here

  15. REMOVE SEAT RECLINING ADJUSTER INSIDE COVER LH

    Click here

  16. REMOVE LIMIT SWITCH ASSEMBLY (for Inner Side)


    1. B004A50C01
      B004C4F Connector
      B004ANI Screw
      B004B1M Remove in this Direction

      Disconnect the connector.

    2. Remove the screw.

    3. Pull in the removal direction shown in the illustration to detach the guides and remove the limit switch assembly.