REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR LH


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:


      • B004A52

        Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • B004BCT

        If this procedure is performed without disconnecting the negative (-) auxiliary battery terminal of the battery, the airbag may deploy even if an impact is applied only to the front airbag sensor LH. Therefore, make sure that the negative (-) auxiliary battery terminal of the battery is disconnected before performing this procedure.

    3. Attach the guide and hold the front airbag sensor LH in place.

    4. Install the front airbag sensor LH with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the front airbag sensor LH has been dropped, replace it with a new one.

      • When installing the front airbag sensor LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the nut while holding the front airbag sensor LH because the front airbag sensor LH guide is easily damaged.

    5. Check that there is no looseness in the installation parts of the front airbag sensor LH.

    6. Connect the airbag connector.


      1. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

        B004C1QC14
        *a Correct *b Incorrect
        *c CPA *d Housing

      2. While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

        B004CNMC01
        *a CPA *b CPA Upper Part
        *c Connection is Completed - -
        B004B1M Connect in this Direction - -

  2. INSTALL QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  3. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    Click here

  4. INSTALL QUARTER INSIDE TRIM BOARD LH

    Click here

  5. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH(FLOOR ANCHOR)

    Click here

  6. INSTALL OUTER LAP BELT ANCHOR COVER

    Click here

  7. INSTALL REAR SEATBACK ASSEMBLY LH

    Click here

  8. INSTALL REAR SEATBACK COVER

    Click here

  9. INSTALL REAR SEAT SIDE GARNISH

    Click here

  10. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  11. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  12. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  13. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  14. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  15. CHECK SRS WARNING LIGHT

    Click here

  16. INITIALIZATION OF SEAT ECU

    Click here