CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. INSTALL AIRBAG ECU ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:


      • B004A52

        Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • B004BCT

        If this procedure is performed without disconnecting the negative (-) auxiliary battery terminal, the airbag may deploy even if an impact is applied only to the airbag ECU assembly. Therefore, make sure that the negative (-) auxiliary battery terminal is disconnected before performing this procedure.

    3. B004BTZC01
      *a Lock Lever
      B004C4F Bolt
      B004BQJ Airbag connector
      B004B1M Lock in this Direction

      Install the airbag ECU assembly with the 3 bolts.

      Torque:
      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.

      • When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the power switch is first turned to ON after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.

    4. Connect the airbag connector and push the connector lock to lock the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that there is no looseness in the installation parts of the airbag ECU assembly.

  2. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL NO .2 DECK BOARD

    Click here

  5. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  6. CHECK SRS WARNING LIGHT

    Click here