FRONT SEAT SIDE AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat airbag assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Front seat assembly LH (Only for removal and installation)

  • Front seat assembly RH (Only for removal and installation)

  • Position control ECU assembly LH (Including removal and installation)

  • Position control ECU assembly RH (Including removal and installation)

  • Front seatback frame sub-assembly LH (Including removal and installation)

  • Front seatback frame sub-assembly RH (Including removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here

Note


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the front seat side airbag was deployed, replace the parts indicated in the chart below according to the specification.

for Standard Seat Type for Sports Seat Type

Front seat airbag assembly LH

Front seatback frame sub-assembly LH

Separate type front seatback pad

Separate type front seatback cover

Front seatback sub-assembly LH

Front seat airbag assembly LH

Front seatback frame sub-assembly LH

Front seatback pad with cover LH

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure as for the RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B004CGW

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  3. REMOVE POSITION CONTROL ECU ASSEMBLY

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  5. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  6. REMOVE LIMIT SWITCH ASSEMBLY

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  8. REMOVE SEAT ADJUSTER COVER CAP LH

    Click here

  9. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH

    Click here

  10. REMOVE FRONT SEATBACK SUB-ASSEMBLY LH (for Standard Seat Type)

    Click here

  11. REMOVE FRONT SEAT HEADREST SUPPORT (for Standard Seat Type)

    Click here

  12. REMOVE FRONT SEAT HEADREST SUPPORT (for Sports Seat Type)

    Click here

  13. REMOVE FRONT UPPER SEATBACK COVER SUB-ASSEMBLY LH (for Standard Seat Type)

    Click here

  14. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Standard Seat Type)

    Click here

  15. REMOVE FRONT SEATBACK PAD WITH COVER LH (for Sports Seat Type)

    Click here

  16. REMOVE SEATBACK CLIMATE CONTROL BLOWER LH

    Click here

  17. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH

    Click here

  18. REMOVE FRONT SEATBACK HOOK

    Click here

  19. REMOVE FRONT SEATBACK SUPPORT LH

    Click here

  20. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

    CAUTION:


    • When storing the front seat airbag assembly LH, keep the airbag deployment side facing upward.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B004A1KC01
    B004CG0 Deployment Side

    1. B004CSE

      Detach the clamp and disconnect the wire harness of the front seat airbag assembly LH.

    2. B004CO6

      Remove the 2 nuts and front seat airbag assembly LH.

      CAUTION:

      Do not reuse the nut.

      Note

      If the seat frame assembly is deformed or damaged, replace it with a new one.

      Tech Tips

      Remove the front seat side support bracket LH together with the airbag.

  21. REMOVE FRONT SEAT SIDE SUPPORT BRACKET LH

    Click here