PEDESTRIAN PROTECTION SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Pedestrian Protection / Data List.

    6. According to the display on the GTS, read the Data List.


      Body Electrical > Pedestrian Protection > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Display Type Information Display Type Information

      LR: Display is indicated by LH / RH

      DP: Display is indicated by Driver Side / Passenger Side

      		 LR -
      The Number of DTCs Number of Past DTCs Min.: 0, Max.: 255 0 -