METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Warm up the engine.

    2. Turn the power switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the power switch on (IG).

    5. Turn the GTS on.

    6. Enter the following menus:


      1. for Combination Meter: Body Electrical / Combination Meter / Data List.

      2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

      3. for Engine: Powertrain / Engine / Data List.

    7. Read the Data List according to the display on the GTS.


      1. Combination Meter


        Body Electrical > Combination Meter > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        ODO/TRIP Change SW ODO/TRIP switch OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
        Engine Rpm Engine speed Min.: 0 rpm, Max.:12750 rpm Almost the same as actual engine speed -
        Coolant Temperature Engine coolant temperature Min.: 0°C (0°F), Max.: 127.5°C(261.5°F) 75 to 100°C (167 to 212°F): After warming up engine -
        Washer Switch Washer fluid level warning switch OFF or ON

        OFF: Washer fluid level not low

        ON: Washer fluid level low

        -
        Oil Level SW Engine oil level sensor OFF or ON

        OFF: Oil level not low

        ON: Oil level low

        -
        Light Control Up Switch Light control rheostat up switch OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Light Control Down Switch Light control rheostat down switch OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        +B Voltage Value Auxiliary battery voltage Min.: 0 V, Max.:25.5 V 11 to 14 V -
        Fuel Input Fuel input Min.: 0 L, Max.:127.5 L
        • Fuel receiver gauge indicates

          F: 80.8 L

        • Fuel receiver gauge indicates

          3/4: 51.6 L

        • Fuel receiver gauge indicates

          1/4: 28.8 L

        • Fuel receiver gauge indicates

          E: 4.6 L

        Unit: Liter
        Sub Fuel Input Sub Fuel Input Min.: 0 L, Max.:127.5 L
        • Fuel receiver gauge indicates

          F: 80.8 L

        • Fuel receiver gauge indicates

          3/4: 51.6 L

        • Fuel receiver gauge indicates

          1/4: 28.8 L

        • Fuel receiver gauge indicates

          E: 4.6 L

        Unit: Liter
        Ambient Temperature Outside temperature Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50 °C (-40 to 122 °F)
        HV System Indicator Hybrid system indicator value Min.: -101%, Max.: 511% -101 to 511% -
        Multi Switch (Up) Steering pad switch(Up) OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Multi Switch (Down) Steering pad switch(Down) OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Multi Switch (Enter) Steering pad switch(Enter) OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Multi Switch (Right) Steering pad switch(Right) OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Multi Switch (Left) Steering pad switch(Left) OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        2nd-Row Seatbelt Buckle (R) Buckle switch (rear RH side) OFF or ON

        OFF: Tongue plate (for Rear RH side) not inserted

        ON: Tongue plate (for Rear RH side) inserted

        *1
        2nd-Row Seatbelt Buckle (L) Buckle switch (rear RH side) OFF or ON

        OFF: Tongue plate (for Rear LH side) not inserted

        ON: Tongue plate (for Rear LH side) inserted

        *1
        Oil Pressure Switch Oil pressure switch OFF or ON

        OFF: Engine started

        ON: Engine not started

        -
        Hazard Flasher Switch Hazard warning signal switch OFF or ON

        OFF: Hazard warning signal switch off

        ON: Hazard warning signal switch on

        -
        Passenger Occupant Detection Switch Occupant detection sensor OFF or ON

        OFF: Front passenger seat not occupied

        ON: Front passenger seat occupied

        -
        Multi Switch (Back) Steering pad switch(Back) OFF or ON

        OFF: Switch released

        ON: Switch pushed

        -
        Brake pad Sensor Signal Brake pad sensor OFF or ON

        OFF: Pad thickness is enough

        ON: Pad is too thin (wear limit)

        -
        Vehicle Proximity Notification System Vehicle proximity notification system OK or NG

        OK: Vehicle proximity notification system normal

        NG: Vehicle proximity notification system abnormal

        -
        Driver Side Seatbelt Warning Buzzer Setting of the driver seatbelt warning buzzer OFF or ON

        OFF: Seatbelt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened

        ON: Seatbelt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened

        Displays customize setting of Driver Side Seatbelt Warning Buzzer
        P-Seatbelt Warning Buzzer Setting of the front passenger seatbelt warning buzzer OFF or ON

        OFF: Seatbelt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seatbelt unfastened

        ON: Seatbelt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seatbelt unfastened

        Displays customize setting of Front Passenger Side Seatbelt Warning Buzzer
        Rear Seatbelt Warning Buzzer Rear seat belt warning buzzer OFF or ON Customized value displayed -
        Reverse Buzzer Setting of flasher sound volume adjustment Large, Medium or Small Displays customize setting of Flasher Sound Volume Adjustment -
        ODO Display Time After IG OFF Setting Setting of the ODO display time after the power switch is turned off 30s, 60s, 600s, OFF Displays customize setting of ODO display time after the power switch is turned off -
        Lane Change Flashing Times Setting Setting of the lane change flashing times OFF, 3, 4, 5, 6, 7 Customized value displayed -
        Flasher Sound Volume Adjustment Existence of function With or Without

        With: With variable gear ratio steering system

        Without: Without variable gear ratio steering system

        -
        TPMS System Existence of function With or Without

        With: With tire pressure warning system

        Without: Without tire pressure warning system

        -
        VGRS System Existence of function With or Without

        With: With variable gear ratio steering system

        Without: Without variable gear ratio steering system

        -
        LDA System Existence of function With or Without

        With: With LDA/LKA system

        Without: Without LDA/LKA system

        -
        PCS System Existence of function With or Without

        With: With pre-collision system

        Without: Without pre-collision system

        -
        Radar Cruise System Existence of function With or Without

        With: With dynamic radar cruise control system

        Without: Without dynamic radar cruise control system

        -
        Clearance Sonar System Existence of function With or Without

        With: With LEXUS parking assist-sensor system

        Without: Without LEXUS parking assist-sensor system

        -
        Road Sign Assist System Existence of function With or Without

        With: With load sign assist system

        Without: Without load sign assist system

        -
        Number of Trouble Code The number of the DTC currently stored Min.: 0, Max.: 255 0 -

        • *1: Although the item is displayed on the GTS, it is not applicable to this vehicle.

      2. ABS/VSC/TRC


        Chassis > ABS/VSC/TRC > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      3. Engine


        Powertrain > Engine > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm for 2ZR-FXE: 950 to 1050 rpm: Idling with warm engine When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
        Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up engine

        This is the engine coolant temperature.

        Tech Tips


        • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

        • After a long soak, the engine coolant temperature, intake air temperature and ambient temperature are approximately equal.

        • If the value is -40°C (-40°F), or 135°C (275°F), the sensor circuit is open or shorted.

        • Check if the engine overheats when the value indicates 135°C (275°F).

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according the display on the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      A/T Indicator Operation 1 Shift indicator OFF, L, 2, 3(M), 4(M), D, N, R, P -
      A/T Indicator Operation 2 Shift indicator OFF, 8, 5, 6, 7, M -
      A/T Indicator Operation 3 Shift indicator OFF, D, SIL (Up), SIL (Down) -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Driver Side Seat Belt Driver or front passenger seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Tail Headlight indicator light OFF or ON -
      Indicat. Lamp Rr FOG Rear fog indicator light OFF or ON -
      Indicat. Pre-Collision PCS warning light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -
      Indicat. Lamp ECB Brake warning light / yellow (minor malfunction) OFF or ON -
      Indicat. Lamp ECT SNOW SNOW indicator light OFF or ON -
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. Clearance Sonar LCD Clearance sonar indicator light OFF or ON -
      Indicat. Ready (HV) Ready indicator light OFF or ON -
      Indicat. Brake Hold Brake hold indicator light OFF or ON -
      Indicat. Hold Brake hold warning light OFF or ON -
      Indicat. Park Parking brake warning light OFF or ON -
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Automatic High Beam Indicator Automatic high beam indicator light OFF or ON -
      PPS Indicator EPS warning light OFF or ON -
      EV Mode Indicator EV mode indicator light OFF or ON -
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
      Check Engine Indicator MIL (Check engine warning light) OFF or ON -
      BSM Control Indicator BSM indicator light OFF or ON -
      RCTA Indicator RCTA indicator light OFF or ON -
      Meter Display 1 Multi-information display OFF, All -

      Tech Tips


      • If not operating normally, it can be judged that there is a malfunction in the combination meter assembly.

      • Indicator lights and warning lights which are not set do not turn on.