ENTRY AND START SYSTEM(for Start Function) DTC CHECK / CLEAR

Note


  • When DTC is output, Be sure to confirm and record.

  • DTCs may have been stored due to problems unrelated to the steering lock function. Be sure to confirm and record any DTCs output for other systems.

  • When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • The steering lock ECU (steering lock actuator or upper bracket assembly) does not store history DTCs. If any DTCs are output, confirm and record them as soon as possible. Do not turn the power switch off or clear the DTCs until the DTCs are confirmed and recorded.


  1. CHECK FOR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the on.

    4. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


      Powertrain > Hybrid Control > Trouble Codes
    5. Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.


      Body Electrical > Power Source Control > Trouble Codes
    6. Enter the following menus: Body Electrical / Entry&Start / Trouble Codes.


      Body Electrical > Entry&Start > Trouble Codes
    7. Check for DTCs.

      Tech Tips


      • The steering lock function DTCs are output from the steering lock ECU (steering lock actuator or upper bracket assembly) via the certification ECU (smart key ECU assembly).

      • When any DTC is not output and security indicator light does not blink, problems may be caused by the following:


        • Open in TC circuit between DLC3 connector and related ECU

        • Malfunction of related ECU

  2. CLEAR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the on.

    4. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


      Powertrain > Hybrid Control > Clear DTCs
    5. Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.


      Body Electrical > Power Source Control > Clear DTCs
    6. Enter the following menus: Body Electrical / Entry&Start / Trouble Codes.


      Body Electrical > Entry&Start > Clear DTCs
    7. Clear the DTCs.