ULTRASONIC SENSOR(for Rear) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 3 LUGGAGE ROOM WIRE


    1. B004C63

      Disconnect the 7 connectors.

    2. Detach the clamps and remove the No. 3 luggage room wire.

  3. REMOVE REAR CORNER ULTRASONIC SENSOR


    1. B004B7Z

      Detach the claws and remove rear corner ultrasonic sensor.

      Note

      Before removing the sensor, make sure to mark the sensor and rear bumper cover so that each sensor can be returned to its original position.

  4. REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER

    Tech Tips

    When removing the rear corner ultrasonic sensor retainer, heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light.


    1. Heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.

      Standard
      Item Temperature
      Rear Bumper Assembly 20 to 30°C (68 to 86°F)
      Rear Corner Ultrasonic Sensor Retainer

      CAUTION:

      B004AM0C01
      *a Heated Part
      *b Heat Light

      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. B004CSP

      Remove the rear corner ultrasonic sensor retainer.

  5. REMOVE REAR CENTER ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure described for the rear corner ultrasonic sensor.

  6. REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER

    Tech Tips

    Use the same procedure described for the rear corner ultrasonic sensor retainer.

  7. REMOVE ULTRASONIC SENSOR CLIP

    Tech Tips


    • When removing the ultrasonic sensor clip, heat the bumper assembly and ultrasonic sensor clip using a heat light.

    • Use the same procedure for the other ultrasonic sensor clips.


    1. Heat the rear bumper assembly and ultrasonic sensor clip using a heat light at the specified temperature for 3 to 5 minutes.

      Standard
      Item Temperature
      Rear Bumper Assembly 20 to 30°C (68 to 86°F)
      Ultrasonic Sensor Clip

      CAUTION:

      B004AM0C01
      *a Heated Part
      *b Heat Light

      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. B004AKV

      Remove the ultrasonic sensor clip.