ULTRASONIC SENSOR(for Front) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 4 ENGINE ROOM WIRE


    1. B000OV1

      Disconnect the 2 connectors.

    2. Detach the clamps and remove the No. 4 engine room wire.

  3. REMOVE FRONT CORNER ULTRASONIC SENSOR


    1. B000O55

      Detach the claws and remove the front corner ultrasonic sensor.

      Note

      Before removing the sensor, make sure to mark the sensor and front bumper cover so that each sensor can be returned to its original position.

  4. REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER

    Tech Tips

    When removing the front corner ultrasonic sensor retainer, heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.


    1. Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.

      Standard
      Item Temperature
      Front Bumper Assembly 20 to 30°C (68 to 86°F)
      Front Corner Ultrasonic Sensor Retainer

      CAUTION:

      B004AM0C01
      *a Heated Part
      *b Heat Light

      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. B004CSP

      Remove the front corner ultrasonic sensor retainer.

  5. REMOVE FRONT CENTER ULTRASONIC SENSOR


    1. B000S8Y

      Detach the claws and remove the front center ultrasonic sensor.

      Note

      Before removing the sensor, make sure to mark the sensor and front bumper cover so that each sensor can be returned to its original position.

  6. REMOVE ULTRASONIC SENSOR CLIP

    Tech Tips


    • When removing the ultrasonic sensor clip, heat the front bumper assembly and ultrasonic sensor clip using a heat light.

    • Use the same procedure for the other ultrasonic sensor clips.


    1. Heat the front bumper assembly and ultrasonic sensor clip using a heat light at the specified temperature for 3 to 5 minutes.

      Heating Temperature
      Item Temperature
      Front Bumper Assembly 20 to 30°C (68 to 86°F)
      Ultrasonic Sensor Clip

      CAUTION:

      B004AM0C01
      *a Heated Part
      *b Heat Light

      • Do not touch the heat light and heated parts.

      • Touching the heat light may result in burns.

      • Touching heated parts for a long time may result in burns.

    2. B004AKV

      Remove the ultrasonic sensor clip.