BLIND SPOT MONITOR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the blind spot monitor sensor removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Blind spot monitor sensor Blind spot monitor beam axis adjustment

  • DTCs are output

  • Blind spot monitor system

Click here

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE BLIND SPOT MONITOR SENSOR LH


    1. B004A01

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor LH.

  3. REMOVE BLIND SPOT MONITOR SENSOR RH

    Tech Tips

    Use the same procedure described for the LH side.