BRAKE HOLD SWITCH INSPECTION

PROCEDURE


  1. INSPECT BRAKE HOLD SWITCH


    1. B000T6ZC01
      *a

      Component without harness connected

      (Brake Hold Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (+B) - 4 (E) Switch pushed Below 1 Ω
      Switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the brake hold switch.

    2. B000T6ZC02
      *a

      Component without harness connected

      (Brake Hold Switch)

      Apply battery voltage to the connector and check the illumination conditions.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (ILL+)

      Battery negative (-) → 5 (ILL-)

      Illuminates

      If the result is not as specified, replace the brake hold switch.