TIRE PRESSURE WARNING SYSTEM, Diagnostic DTC:C2179/79

DTC Code DTC Name
C2179/79 Tire Pressure Monitor ECU Communication Stop

DESCRIPTION

The main body ECU (multiplex network body ECU) sends signals to the tire pressure warning ECU and receiver via a direct line.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C2179/79 Tire Pressure Monitor ECU Communication Stop Communication between the main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver is interrupted for 10 seconds or more.

  • Main body ECU (Multiplex network body ECU)

  • Wire harness or connector

  • Tire pressure warning ECU and receiver

 -

WIRING DIAGRAM

B004B85E61

CAUTION / NOTICE / HINT

Note


  • When replacing the tire pressure warning ECU and receiver, first use the GTS to record all of the current IDs and registered tires with transmitters (4 or 5 tires) of the tire pressure warning valve and transmitter registered to the tire pressure warning ECU and receiver.

  • It is necessary to perform initialization after registration Click here of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.

  • Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))


    1. Disconnect the X45*1 or X78*2 tire pressure warning ECU and receiver connector.


      • *1: w/ Rear Fog Light

      • *2: w/o Rear Fog Light

    2. Disconnect the P9 main body ECU (multiplex network body ECU) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      w/ Rear Fog Light
      Tester Connection Condition Specified Condition
      X45-5 (PRG) - P9-11 (PRG) Always Below 1 Ω
      X45-5 (PRG) or P9-11 (PRG) - Body ground Always 10 kΩ or higher
      w/o Rear Fog Light
      Tester Connection Condition Specified Condition
      X78-5 (PRG2) - P9-11 (PRG) Always Below 1 Ω
      X78-5 (PRG2) or P9-11 (PRG) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. Replace the tire pressure warning ECU and receiver.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK DTC OUTPUT


    1. Clear the DTCs.

      Click here


      Chassis > Tire Pressure Monitor > Clear DTCs

    2. Turn the power switch off.

    3. Turn the power switch on (IG).

    4. Check for DTCs.

      Click here


      Chassis > Tire Pressure Monitor > Trouble Codes
      OK
      DTC C2179/79 is not output.
      Result
      Proceed to
      OK
      NG

    OK

    END

    NG

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here