SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE


  1. INSTALL ABSORBER CONTROL ECU


    1. Install the absorber control ECU with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

  2. INSTALL REAR STEERING CONTROL ECU (w/ Dynamic Rear Steering)

    Click here

  3. INSTALL STEREO COMPONENT EQUALIZER ASSEMBLY (w/ Dynamic Rear Steering)

    Click here

  4. INSTALL NO. 2 DECK BOARD BRACKET


    1. w/o Dynamic Rear Steering:


      1. B004B39

        Install the No. 2 deck board bracket with the 3 bolts.

        Torque:
        15.8 N*m  { 161 kgf*cm, 12 ft.*lbf }

      2. Connect the 3 connectors.

    2. w/ Dynamic Rear Steering:


      1. B004AOQ

        Install the No. 2 deck board bracket with the 3 bolts.

        Torque:
        15.8 N*m  { 161 kgf*cm, 12 ft.*lbf }

      2. Connect the 3 connectors.

      3. B004CISC04
        *a Lock of the Lock Lever
        *b Lock Lever

        Connect the 3 connectors to the rear steering control ECU.

        Tech Tips

        When connecting the connector with lock lever, return the lock lever to its original position and securely push in the lock of the lock lever as shown in the illustration.

  5. INSTALL INNER LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  6. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  7. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  8. INSTALL REAR FLOOR FINISH PLATE

    Click here

  9. INSTALL SIDE TRIM BOX

    Click here

  10. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  11. INSTALL NO. 1 DECK BOARD

    Click here

  12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

      Click here

  13. INSTALL NO. 2 DECK BOARD

    Click here