HEIGHT CONTROL SENSOR(for Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B004AJI

      Install the front height control sensor sub-assembly LH with the 2 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not drop the front height control sensor sub-assembly LH. If it is dropped, replace it with a new one.

    2. B004BPU

      Install the front height control sensor link to No.2 front lower suspension arm LH with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    3. B004AFY

      Install the wire harness clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    4. Engage the clamp.

    5. Connect the connector.

    6. B004AF8

      Install the wire harness clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  2. INSTALL FRONT WHEEL LH

    Click here

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL NO. 2 DECK BOARD

    Click here