FRONT AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1341, C1342, C1343 and/or C1344 may be stored. As there is no malfunction, clear the DTCs.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. DISCONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here

  2. REMOVE FRONT WHEEL

    Click here

  3. DISCONNECT DISC BRAKE CYLINDER ASSEMBLY

    Click here

  4. REMOVE FRONT DISC LH

    Click here

  5. REMOVE FRONT AXLE HUB BOLT


    1. B004AIUC01
      *a Service Nut
      *b Hold
      *c Turn

      Temporarily install 2 service nuts to the front axle hub bolts as shown in the illustration.

      Recommended Service Nut
      Thread diameter: 14.0 mm (0.551 in.)
      Thread pitch: 1.5 mm (0.0591 in.)

      Note

      Install the service nuts to prevent damage to the front axle hub bolts.

    2. Using SST and a screwdriver or an equivalent tool to hold the front axle hub, remove the front axle hub bolt.

      SST
      09650-17011

      Note

      Do not damage the threads of the front axle hub bolts.

  6. INSTALL FRONT AXLE HUB BOLT


    1. Temporarily install a new front axle hub bolt to the front axle hub.

    2. B004BTJC01
      *a Service Nut
      *b Washer
      *c Hold
      *d Turn

      Install a washer and service nut to a new front axle hub bolt as shown in the illustration.

      Recommended Service Nut
      Thread diameter: 14.0 mm (0.551 in.)
      Thread pitch: 1.5 mm (0.0591 in.)

      Tech Tips

      Recommended washer thickness is 5 mm (0.197 in.) or more.

    3. Using a screwdriver or an equivalent tool to hold the front axle hub, install the front axle hub bolt by tightening the service nut.

      Note


      • Install the service nuts to prevent damage to the front axle hub bolts.

      • Do not damage the threads of the front axle hub bolts.

    4. Remove the 3 service nuts and washer from the 3 front axle hub bolts.

  7. INSTALL FRONT DISC LH

    Click here

  8. CONNECT DISC BRAKE CYLINDER ASSEMBLY

    Click here

  9. INSTALL FRONT WHEEL

    Click here

  10. CONNECT BRAKE BOOSTER PUMP CONNECTOR

    Click here