SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here


  • Air leaks from intake system

  • Gas leaks from exhaust system

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

w/ Canister Pump Module: Click here

w/o Canister Pump Module: Click here

Suspension, tires, etc*1 Television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click here

*1: The vehicle height changes due to suspension or tire replacement.

CAUTION:


  • B004A7G

    Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

    Click here

  • B004BJX

    To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

  • B004CM2

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

  • B004CN9C01
    *a An Object Exceeding Weight Limit of Engine Lifter

    The engine assembly with transmission is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transmission may fall off the engine lifter.

  • B004AUYC01
    *a Object Exceeding Weight Limit of Transmission Jack

    The hybrid vehicle transmission assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.

Note

After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH HYBRID TRANSMISSION

    Click here

  2. REMOVE TRANSMISSION REVOLUTION SENSOR

    B004CK3C01

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and the transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.