SHIFT PADDLE SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission shift switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Auxiliary battery terminal isdisconnected/reconnected Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Parts between the steering wheel and tires have been removed/installed, replaced or adjusted Perform Actuator Angle Neutral Point Calibration and Initialization

  • Variable gear ratio steering system

  • Steering wheel off-center

  • DTCs are output

Click here

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  3. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  4. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. B000NX8

      Remove the 2 screws and disconnect the 2 transmission shift switch assemblies.

    2. for transmission shift switch assembly LH side:


      1. B000QBAC01
        *1 Transmission Shift Switch Assembly
        *2 No. 2 Switch Wire
        *a Protective Tape
        B004B1M Lift Up Vertically

        Using a screwdriver with its tipped wrapped with protective tape, detach the 2 claws and No. 2 switch wire from the guide and lift the transmission shift switch assembly perpendicular from the steering wheel assembly and disconnect it as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

      2. B000QSW

        Disconnect the No. 2 switch wire connector and remove the transmission shift switch assembly.

    3. for transmission shift switch assembly RH side:


      1. B000NZVC01
        *1 Transmission Shift Switch Assembly
        *2 No. 2 Switch Wire
        *a Protective Tape
        B004B1M Lift Up Vertically

        Using a screwdriver with its tipped wrapped with protective tape, detach the 2 claws and No. 2 switch wire from the guide and lift the transmission shift switch assembly perpendicular from the steering wheel assembly and disconnect it as shown in the illustration.

        Tech Tips

        Tape the screwdriver tip before use.

      2. B000OMT

        Disconnect the No. 2 switch wire connector and remove the transmission shift switch assembly.

  5. REMOVE LOWER STEERING WHEEL BOSS COVER (w/o Steering Heater)

    Click here

  6. DISCONNECT LOWER STEERING WHEEL BOSS COVER (w/ Steering Heater)

    Click here

  7. REMOVE NO. 2 SWITCH WIRE (w/o Steering Heater)


    1. B000PZ3

      Disconnect the 2 guides and remove the No. 2 switch wire from the lower steering wheel boss cover.

  8. REMOVE NO. 2 SWITCH WIRE (w/ Steering Heater)


    1. B000PE7

      Disconnect the 2 guides and remove the No. 2 switch wire from the lower steering wheel boss cover.