TRANSMISSION WIRE REMOVAL

PROCEDURE

DRAIN TRANSMISSION FLUID
1. Remove the drain plug and gasket, and then drain the transmission fluid.
2. *1 Gasket
  
  Install a new gasket and drain plug.
  
  Torque:
  
  20 N*m { 204 kgf*cm, 15 ft.*lbf }
  
  Note
  
  Install the flat side of the gasket to the drain plug side.

REMOVE TRANSMISSION OIL PAN SUB-ASSEMBLY

Remove the 8 bolts, transmission oil pan sub-assembly and transmission oil pan gasket from the hybrid vehicle transmission assembly.

Remove the 4 oil cleaner magnets from the transmission oil pan sub-assembly.

Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the transmission oil pan sub-assembly and on the magnets to guess the type of wear which might be found in the hybrid vehicle transmission assembly.

Result
Steel (magnetic)
Bearing, gear and plate wear
Brass (non-magnetic)
Bushing wear

REMOVE OIL STRAINER ASSEMBLY
1. Remove the 3 bolts and oil strainer assembly from the transmission valve body assembly.
2. *1 O-ring
  
  Remove the O-ring from the oil strainer assembly.
REMOVE TRANSMISSION WIRE
1. *1 Temperature Sensor
  
  *2 Lock Plate
  
  Remove the bolt and lock plate, and disconnect the temperature sensor from the transmission valve body assembly.
2. Remove the O-ring from the temperature sensor.
3. Detach the wire harness clamp.
4. Disconnect the 7 connectors from the transmission valve body assembly.
5. Pull Down
  
  Disconnect the transmission wire connector.
  
  Tech Tips
  
  Disengage the claw, pull down the lever, and then disconnect the transmission wire connector.
6. *a 10 mm Union Nut Wrench
  
  Turn
  
  Using a 10 mm union nut wrench, remove the bolt.
7. Pull out the transmission wire.
8. Remove the O-ring from the transmission wire.

*1	Temperature Sensor
*2	Lock Plate

*a	10 mm Union Nut Wrench
	Turn