DRIVING SUPPORT ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

    Note

    Do not use a driving support ECU if it has been dropped or has been subjected to any strong impact.


    1. B004A7F

      Install the driving support ECU assembly with nut.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    2. Connect the connector and attach the wire harness clamp.

  2. INSTALL HEATER TO REGISTER CENTER SUB DUCT

    Click here

  3. INSTALL NO. 2 AIR DUCT

    Click here

  4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. INSTALL NO. 2 DECK BOARD

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here