FORWARD RECOGNITION CAMERA SYSTEM Power Source Circuit

DESCRIPTION

This circuit provides power to operate the forward recognition camera.

WIRING DIAGRAM

B000QGBE11
*1 from IG Circuit
*2 IG1 D NO. 2
*3 Forward Recognition Camera

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE VOLTAGE)


    1. B004CIDC89
      *a

      Front view of wire harness connector

      (to Forward Recognition Camera)

      Disconnect the a1 forward recognition camera connector.

    2. Turn the power switch on (IG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      a1-7 (IGB) - Body ground Power switch on (IG) 11 to 14 V

    4. Connect the a1 forward recognition camera connector.

      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    OK

  2. CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)


    1. Disconnect the a1 forward recognition camera connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      a1-10 (GND) - Body ground Always Below 1 Ω

    3. Connect the a1 forward recognition camera connector

      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)