OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

   
   

   1. Remove any oil from the threads of the engine oil pressure switch assembly.

   2. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

   3. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:

      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

   4. Connect the engine oil pressure switch connector.

2. ADD ENGINE OIL

   Click here

3. INSPECT FOR OIL LEAK

   Click here

4. INSPECT ENGINE OIL LEVEL

   Click here

5. INSTALL LOWER RADIATOR AIR DEFLECTOR

   Click here

6. INSTALL RADIATOR SUPPORT TO FRAME SEAL RH

   Click here