EXHAUST PIPE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the exhaust pipe removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B000RKV

PROCEDURE


  1. REMOVE REAR FLOOR SIDE MEMBER COVER LH


    1. B000Q5C

      Remove the 2 clips, 3 bolts, nut, screw and rear floor side member cover LH.

  2. REMOVE REAR FLOOR SIDE MEMBER COVER RH


    1. B000OQJ

      Remove the 2 clips, 3 bolts, nut, screw and rear floor side member cover RH.

  3. REMOVE FRONT FENDER SEAL LH


    1. B000PGD

      Remove the 3 clips, grommet and front fender seal LH.

  4. REMOVE FRONT FENDER SEAL RH


    1. B000SFU

      Remove the 3 clips, grommet and front fender seal RH.

  5. REMOVE FRONT FLOOR COVER LH


    1. B000PMR

      Remove the 4 grommets, 6 clips, nut, bolt and front floor cover LH.

  6. REMOVE FRONT FLOOR COVER RH


    1. B000P37

      Remove the 4 grommets, 6 clips, nut, bolt and front floor cover RH.

  7. REMOVE FRONT FLOOR BRACE SUB-ASSEMBLY CENTER


    1. B000TDV

      Remove the 12 bolts and front floor brace sub-assembly center.

  8. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR


    1. B000S4O

      Remove the 3 nuts and No. 2 differential support protector.

  9. REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR


    1. B000T33

      Remove the 3 nuts and No. 1 differential support protector.

  10. REMOVE REAR NO. 4 BUMPER SIDE SUPPORT LH


    1. B000RY1

      Remove the 2 screws, 2 clips, grommet and rear No. 4 bumper side support LH.

  11. REMOVE REAR NO. 4 BUMPER SIDE SUPPORT RH


    1. B000S24

      Remove the 2 screws, 2 clips, grommet and rear No. 4 bumper side support RH.

  12. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. B000SC0

      Remove the 4 bolts and 4 nuts to disconnect the front exhasut pipe assembly from the exhaust manifold assembly LH and exhaust manifold assembly RH.

    2. B000PW3

      Remove the 4 bolts, 4 nuts and front exhaust pipe assembly from the exhaust tailpipe assembly.

    3. Remove the 4 gaskets.

  13. REMOVE EXHAUST TAILPIPE ASSEMBLY


    1. B000SZ4

      Remove the 6 exhaust pipe supports and exhaust tailpipe assembly.