EXHAUST MANIFOLD COMPONENTS
ILLUSTRATION
| *1 | AIR CLEANER WITH AIR CLEANER HOSE | *2 | FRONT FENDER APRON INSULATOR LH |
| *3 | GENERATOR CABLE | *4 | MOTOR CABLE |
| *5 | INVERTER MOTOR CABLE BRACKET ASSEMBLY | *6 | LOWER RADIATOR AIR DEFLECTOR |
| *7 | NO. 1 AIR CLEANER INLET | *8 | NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE |
| *9 | RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH | *10 | RADIATOR SUPPORT TO FRAME SEAL RH |
| *11 | V-BANK COVER SUB-ASSEMBLY | *12 | ENGINE OIL LEVEL DIPSTICK |
| *13 | O-RING | *14 | FENDER APRON BRACE SUB-ASSEMBLY RH |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | ENGINE SIDE COVER RH | *2 | FRONT FENDER SEAL LH |
| *3 | FRONT FENDER SEAL RH | *4 | FRONT FLOOR BRACE SUB-ASSEMBLY CENTER |
| *5 | FRONT FLOOR COVER LH | *6 | FRONT FLOOR COVER RH |
| *7 | NO. 2 ENGINE UNDER COVER ASSEMBLY | *8 | REAR FLOOR SIDE MEMBER COVER LH |
| *9 | REAR FLOOR SIDE MEMBER COVER RH | *10 | REAR LOWER ARM MOUNTING REINFORCEMENT SUB-ASSEMBLY RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | EXHAUST MANIFOLD ASSEMBLY LH | *2 | EXHAUST MANIFOLD ASSEMBLY RH |
| *3 | FRONT EXHAUST PIPE ASSEMBLY | *4 | NO. 1 EGR PIPE |
| *5 | NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY | *6 | GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) | *2 | AIR FUEL RATIO SENSOR (for Bank 1 Sensor 2) |
| *3 | AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) | *4 | AIR FUEL RATIO SENSOR (for Bank 2 Sensor 2) |
| *5 | NO. 1 EXHAUST MANIFOLD HEAT INSULATOR | *6 | NO. 1 MANIFOLD CONVERTER INSULATOR |
| *7 | NO. 2 MANIFOLD CONVERTER INSULATOR | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |