FUEL TANK PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL REAR FUEL TANK SIDE PLATE SUB-ASSEMBLY


    1. Install a new gasket and the fuel tank evap tube support plate to the fuel tank protector plate.

    2. Install the fuel tank protector plate to the fuel tank assembly with the 4 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
    3. B000TO8

      Set the fuel tank pressure sensor to the fuel tank evap tube support plate.

      Note

      Check that there are no scratches or foreign objects on the connecting parts.

    4. B000RK3

      Install the fuel tank pressure sensor with the tube joint clip.

      Note

      B000P5IC01
      *1 Fuel Tank Pressure Sensor
      *2 Tube Joint Clip
      *a O-Ring
      *b CORRECT
      *c INCORRECT

      • Check that the tube joint clip is inserted securely.

      • After installing the tube joint clip, check that the fuel tank pressure sensor cannot be pulled off.

      • Be careful not to damage the tube joint clip. If the tube joint clip is damaged, replace it.

    5. Connect the connector to the fuel tank pressure sensor.

  2. INSTALL NO. 3 FUEL TANK PROTECTOR


    1. B000PNUC01
      *a Turn
      *b Lock

      Set the No. 3 fuel tank protector to the fuel tank protector plate.

    2. Turn the No. 3 fuel tank protector and install the No. 3 fuel tank protector to the fuel tank protector plate securely. Then secure the lock.

  3. INSTALL FUEL TANK ASSEMBLY

    Click here