FUEL TANK PRESSURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank pressure sensor(vapor pressure sensor assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane-keeping assist system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

PROCEDURE


  1. REMOVE FUEL TANK ASSEMBLY

    Click here

  2. REMOVE NO. 3 FUEL TANK PROTECTOR


    1. B004CQQC01
      *a Turn
      *b Lock

      Release the lock and then turn the No. 3 fuel tank protector, and remove the No. 3 fuel tank protector from the fuel tank protector plate.

  3. REMOVE REAR FUEL TANK SIDE PLATE SUB-ASSEMBLY


    1. Disconnect the connector from the fuel tank pressure sensor.

    2. B004C2E

      Remove the tube joint clip and fuel tank pressure sensor from the fuel tank evap tube support plate.

      Note


      • Before removing the tube joint clip, check for foreign matter around the tube joint clip. Clean if necessary.

      • Keep the O-ring free of foreign matter, as it becomes contaminated easily.

      • Do not use any tools in this procedure.

      • Be careful not to damage the tube joint clip. If the tube joint clip is damaged, replace it.

    3. B004CFL

      Remove the 4 screws and fuel tank protector plate from the fuel tank assembly.

    4. B004AUAC01
      *1 Fuel Tank Protector Plate
      *2 Fuel Tank Evap Support Plate
      *3 Gasket

      Remove the gasket and fuel tank evap tube support plate from the fuel tank protector plate.