FUEL VAPOR CONTAINMENT VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel vapor containment valve (fuel tank solenoid main valve assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane-keeping assist system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

PROCEDURE


  1. REMOVE FUEL TANK CAP ASSEMBLY


    1. B004BQB

      Press the lid opener switch to release the pressure in the fuel tank.

    2. Remove the fuel tank cap assembly.

  2. REMOVE REAR SUSPENSION MEMBER WITH DIFFERENTIAL CARRIER

    Click here

  3. DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY


    1. Disconnect the 2 fuel tank vent hose sub-assemblies from the fuel tank solenoid valve with hose assembly.


      1. B004CITC01
        *a Retainer
        B004C4F Pinch
        B004ANI Up

        Pinch the retainer and raise it.

        Note


        • Do not use any tools in this procedure.

        • Check for any dirt and foreign matter contamination in the fuel tank solenoid valve with hose assembly and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the fuel tank solenoid valve with hose assembly and connector.

        Tech Tips

        Do not remove the retainer.

      2. Disconnect the fuel tank vent hose sub-assembly from the fuel tank solenoid valve with hose assembly.

  4. REMOVE FUEL TANK SOLENOID VALVE WITH HOSE ASSEMBLY


    1. B004B4G

      Detach the clamp and disconnect the connector from the fuel tank solenoid valve with hose assembly.

    2. B004CFZ

      Remove the 2 nuts and fuel tank solenoid valve with hose assembly from the body.

  5. REMOVE FUEL TANK SOLENOID MAIN VALVE ASSEMBLY


    1. B004B20

      Remove the 2 nuts and fuel tank solenoid main valve assembly from the charcoal canister bracket sub-assembly.