FUEL SENDER GAUGE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

CAUTION:


  • B004CJ8

    Never perform work on fuel system components near any possible ignition sources.

  • Vaporized fuel could ignite, resulting in a serious accident.


  • B004AP0

    Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

  • Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

PROCEDURE


  1. REMOVE NO. 2 DECK BOARD

    Click here

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work.

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE NO. 1 REAR FLOOR SERVICE HOLE COVER


    1. B004AM6

      Remove the No. 1 rear floor service hole cover.

    2. Disconnect the No. 2 fuel sender gauge assembly connector.

  7. REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY


    1. B004BB0

      Remove the 5 screws and No. 2 fuel sender gauge assembly.

  8. REMOVE NO. 2 REAR FLOOR SERVICE HOLE COVER

    Click here

  9. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

    Click here

  10. REMOVE FUEL TANK VENT TUBE SET PLATE

    Click here

  11. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  12. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. B004AMP

      Disconnect the fuel sender gauge assembly connector.

    2. Detach the claw and slide the fuel sender gauge assembly upward to remove it.