RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT IGNITION CONTROL RELAY (IGCT NO. 1)


    1. B000QKL

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the ignition control relay (IGCT No. 1).

  2. INSPECT HYBRID WATER PUMP RELAY (INV W/PMP)


    1. B000QU9N03

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the hybrid water pump relay (INV W/PMP).

  3. INSPECT BATTERY BLOWER RELAY NO.1 (BATT FAN NO. 1)


    1. B000QU9N03

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the blower relay No. 1 (BATT FAN No. 1).