DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT

    Tech Tips

    When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.


    1. B000ST3

      Partially mount the V-ribbed belt on the engine water pump assembly as shown in the illustration. Mount the V-ribbed belt around the engine water pump assembly partially as shown in the illustration.

      Note


      • Make sure the V-ribbed belt is securely mounted on the crankshaft pulley assembly.

      • Do not allow slack in the V-ribbed belt.

    2. B000STU

      While holding the V-ribbed belt on the engine water pump assembly by hand as shown in the illustration, gradually rotate the crankshaft pulley assembly clockwise to mount the V-ribbed belt on the engine water pump assembly.

      CAUTION:

      Do not hold any other parts of the V-ribbed belt, or your fingers may get caught between the V-ribbed belt and engine water pump assembly as they are rotated.

      Note


      • Guide the V-ribbed belt into the grooves of the engine water pump assembly as the crankshaft pulley assembly is rotated.

      • Make sure the V-ribbed belt is not inside out.

    3. B000PY7C07
      *a Correct
      *b Incorrect

      Rotate the crankshaft pulley assembly until the V-ribbed belt is fully mounted on the engine water pump assembly.

    4. Check that the V-ribbed belt is securely mounted on the crankshaft pulley assembly and engine water pump assembly.

      Note

      Make sure the ribs of the V-ribbed belt are not cracked.

    5. Start the engine and check that the V-ribbed belt turns smoothly without any noise.

  2. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  3. INSTALL RADIATOR SUPPORT TO FRAME SEAL RH

    Click here

  4. INSTALL LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here