ACTIVE NOISE CONTROL ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the active noise control ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Absorber Control ECU Registration of Vehicle Identification Information

  • Interrupts damping force control

  • DTCs are stored

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting cable from the negative auxiliary battery terminal. Therefore, make sure to read the disconnecting the negative auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 2 DECK BOARD BRACKET

    Click here

  5. REMOVE STEREO COMPONENT EQUALIZER ASSEMBLY


    1. B0049TF

      Remove the 2 nuts and stereo component equalizer assembly.