AUDIO AND VISUAL SYSTEM Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT

Note

The following malfunctions may occur if a radio receiver assembly from another vehicle is installed to this vehicle. Therefore, when replacing the radio receiver assembly, be sure to replace it with new one.


  • Communication malfunction DTC is output

  • Does not operate normally

Tech Tips

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE


  1. START DIAGNOSTIC MODE


    1. Activate diagnostic mode and check if the "Service Menu" screen can be displayed.

      Click here

      OK
      Diagnostic mode can be activated.
      Result
      Proceed to
      OK
      NG

    NG

    REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK) Click here

    OK

  2. CHECK PANEL SWITCH (OPERATION CHECK)


    1. B004BYE

      Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.

      Click here

    2. Operate the abnormal switch and check if the switch status is correctly displayed.

      OK
      The switch status is correctly displayed as operated.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    NG

  3. REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK)


    1. Enter self-diagnostic mode.

      Click here

    2. B004COYC01
      *a Switch Illumination
      *b Touch Screen

      Operate the remote touch screen in the upper left to turn the switch illumination off.

      Note

      Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch in self-diagnostic mode.

    3. With the switch illumination turned off, press each switch of the remote touch and check that the switch illumination turns on.

      Result
      Result Proceed to
      Self check mode cannot be activated. A
      Some switches do not turn on the switch illumination when they are pressed.
      All switches turn on the switch illumination when they are pressed. B

    A

    REPLACE REMOTE OPERATION CONTROLLER ASSEMBLY (REMOTE TOUCH) Click here

    B

    REPLACE RADIO RECEIVER ASSEMBLY Click here