STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Parts between the steering wheel and tires have been removed/installed, replaced or adjusted Perform Actuator Angle Neutral Point Calibration and Initialization

  • Variable gear ratio steering system

  • Steering wheel off-center

  • DTCs are output

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE HORN BUTTON ASSEMBLY

    Click here

  4. REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. w/ Steering Heater:


      1. B000TKI

        Disconnect the connector from the steering wheel heater control assembly.

    3. B000PHGC01
      *a Matchmark

      Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. B000SWDC01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-40011   ( 09957-04010 )
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )
      09950-60010   ( 09951-00220 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  5. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  6. REMOVE LOWER STEERING WHEEL BOSS COVER (w/o Steering Heater)


    1. B000P8E

      Detach the 4 claws and remove the 2 screws and lower steering wheel boss cover from the steering wheel assembly.

  7. DISCONNECT LOWER STEERING WHEEL BOSS COVER (w/ Steering Heater)

    Click here

  8. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY

    Click here