FRONT BUMPER INSTALLATION

PROCEDURE


  1. INSTALL FRONT BUMPER COVER


    1. B000TUBC01
      B000WYJ Install in this Direction (1)
      B000YNM Install in this Direction (2)
      B000WCG Protective Tape

      Connect the headlight cleaner hose as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH and LH sides.

    2. Apply protective tape around the front bumper cover.

    3. Attach the claws to temporarily install the front bumper cover.

      Note

      Do not damage the front bumper assembly.

    4. B000XI1

      Connect the connector of the front turn signal light assembly.

      Note

      Do not pull on the front fender liner too hard when folding back the edge.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. B000VP4C01
      B000WYJ Install in this Direction (1)
      B000YNM Install in this Direction (2)

      Attach the claws to install the front bumper cover as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Remove the protective tape.

    7. B000YPW

      w/ Dynamic Radar Cruise Control System:


      1. Connect the connector of the millimeter wave radar sensor assembly.

    8. B000VDCC01
      B000WYJ Install in this Direction

      Attach the clips and install the radiator grille protector.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    9. B000U5E

      Install the 2 clips and 4 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
    10. B000VSA

      Install the 8 screws.

    11. B000YFUC01
      B000WYJ Install in this Direction

      Install the front side bumper retainer.

      Tech Tips

      Use the same procedure for the RH side and LH side.


      1. Attach the clips to install the front side bumper retainer LH as shown in the illustration.

      2. Install the screw.

      3. Install the clip to the front fender liner.

    12. B000Y1YC01
      *a Correct
      *b Incorrect

      Install the front bumper cover with the 3 pin hold clips.

      Note


      • Insert the pin hold clip with the slot aligned vertically.

      • Do not rotate the pin hold clip after inserting it.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. INSTALL LOWER RADIATOR AIR DEFLECTOR

    B000VVX

    1. Attach the guides and install the lower radiator air deflector.

    2. Install the 5 clips.

  3. INSTALL RADIATOR SUPPORT TO FRAME SEAL LH


    1. B000URB

      Attach the guides and claws and install the radiator support to frame seal LH.

    2. Install the 3 clips.

  4. INSTALL RADIATOR SUPPORT TO FRAME SEAL RH


    1. B000TRT

      Attach the guides and claws and install the radiator support to frame seal RH.

    2. Install the 6 clips.

  5. ADD WINDSHIELD WASHER FLUID

    Click here

  6. PERFORM INITIALIZATION

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. When disassembly the front bumper assembly:

      Click here

  8. CHECK SRS WARNING LIGHT


    1. When disassembly the front bumper assembly:

      Click here

  9. HEADLIGHT AIMING


    1. When removing and installing the headlight assembly:

      Click here