FRONT BUMPER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

PROCEDURE


  1. REMOVE RADIATOR SUPPORT TO FRAME SEAL RH


    1. B000TRT

      Remove the 6 clips.

    2. Detach the guides and claws and remove the radiator support to frame seal RH.

  2. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH


    1. B000VVO

      Remove the 6 clips.

    2. Detach the guides and claws and remove the radiator support to frame seal LH.

  3. REMOVE LOWER RADIATOR AIR DEFLECTOR


    1. B000VVX

      Remove the 5 clips.

    2. Detach the guide and remove the lower radiator air deflector.

  4. REMOVE FRONT BUMPER COVER


    1. B000U5YC01
      B000WCG Protective Tape

      Apply protective tape around the front bumper cover.

    2. B000Y0QC01
      *a 90°

      Using a screwdriver, turn the pin hold clip 90° and remove the 3 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. B000W4RC01
      B000WYJ Remove in this Direction

      Remove the front side bumper retainer LH.

      Tech Tips

      Use the same procedure for the RH side and LH side.


      1. Remove the clip from the front fender liner.

      2. Remove the screw.

      3. Remove the clips and front bumper side retainer LH as shown in the illustration.

    4. B000VSA

      Remove the 8 screws.

    5. B000U5E

      Remove the 4 bolts.

    6. Remove the 2 clips.

    7. B000VTHC01
      B000WYJ Separate Direction

      Detach the clips and separate the radiator grill protector.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. B000YPW

      w/ Dynamic Radar Cruise Control System:


      1. Disconnect the connector of the millimeter wave radar sensor assembly.

    9. B000X4RC01
      B000WYJ Remove in this Direction (1)
      B000YNM Remove in this Direction (2)
      B000WCG Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, detach the claw while pulling toward the outside of the vehicle and remove the front bumper cover as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    10. B000XI1

      Disconnect the connector of the front turn signal light assembly.

      Note

      When folding back the edge of the front fender liner, do not pull too hard.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    11. B000X5EC01
      B000WYJ Remove in this Direction (1)
      B000YNM Remove in this Direction (2)

      Detach the claws and remove the front bumper cover as shown in the illustration.

    12. Disconnect the headlight cleaner hose.

      Tech Tips


      • Prepare a container before performing the procedure.

      • Use the same procedure for the RH side and LH side.