DESCRIPTION
The spoiler control ECU assembly receives vehicle speed signals from the skid control ECU assembly via CAN communication. When only automatic operation of the active rear wing does not operate, the vehicle speed indicated by the vehicle speed signal may not match the actual vehicle speed.
CAUTION / NOTICE / HINT
Note
The specified vehicle speed at which automatic operation raises the active rear wing differs depending on the selected driving mode. When any driving mode other than ECO mode is selected, the active rear wing will rise at approximately 80 km/h (50 mph), and when ECO mode is selected, it will rise at approximately 130 km/h (81 mph).
When a manual operation is performed, automatic operation will be temporarily prohibited until specified conditions are met.
The active rear wing system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
PROCEDURE
CHECK FOR DTC
Check for DTCs.
| OK |
|---|
| DTCs are not output. |
| Result | |||
|---|---|---|---|
|
| NG |
|
GO TO DIAGNOSTIC TROUBLE CODE CHART Click here |
| OK |
|
READ VALUE USING GTS (VEHICLE SPEED)
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Active Rear Wing / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Vehicle speed | 0 km/h (0 mph) to 326 km/h (202 mph) | Almost the same as actual vehicle speed | - |
| Tester Display |
|---|
| Vehicle Speed |
| OK |
|---|
| The vehicle speed displayed on the GTS is almost the same as the actual vehicle speed. |
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE SPOILER CONTROL ECU ASSEMBLY Click here |
| NG |
|
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here |