STOP LIGHT SWITCH REMOVAL

CAUTION / NOTICE / HINT

for LHD:

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the stop light switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative(-) battery terminal	Memorize steering angle neutral point	LKA/LDA system	Click here
		Pre-collision system	Click here
		Parking assist monitor system	Click here
	Steering sensor zero point calibration	Variable gear ratio steering system	Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE NO. 2 DECK BOARD (for LHD)

Click here
PRECAUTION (for LHD)

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LHD)
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU (for LHD)

Click here
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

Click here
REMOVE STOP LIGHT SWITCH ASSEMBLY
1. Disconnect the connector.
2. Turn the stop light switch assembly counterclockwise and remove it.
REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
1. Protective Tape
  
  Using a screwdriver, detach the claw and remove the stop light switch mounting adjuster.
  
  Note
  
  The stop light switch mounting adjuster must not be reused.
  
  Tech Tips
  
  Tape the screwdriver tip before use.