SWITCH HOUSING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL STEERING WHEEL SWITCH HOUSING


    1. B000X59

      If reusing the steering wheel switch housing:


      1. Using pliers, support the band clamp while loosened and set the steering wheel switch housing.

      2. B000XHFC01
        B000WYJ Install in this Direction

        Push the steering wheel switch housing forward to attach the claw to install it.

      3. B000VBU

        Tighten the band clamp.

    2. If install a new steering wheel switch housing:


      1. B000TZU

        Set the steering wheel switch in place.

      2. B000U4ZC01
        B000WYJ Install in this Direction

        Push the steering wheel switch housing forward to attach the claw to install it.

      3. B000UXGC01
        B000WYJ Remove in this Direction

        Remove the pin to tighten the band clamp.

  2. INSTALL TURN SIGNAL SWITCH

    Click here

  3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

    Click here

  4. INSTALL TILT AND TELESCOPIC SWITCH

    Click here

  5. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. INSTALL NO. 2 DECK BOARD

    Click here

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  9. CHECK SRS WARNING LIGHT

    Click here