SWITCH HOUSING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel switch housing removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative(-) battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE NO. 2 DECK BOARD

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    B000W7Y

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B000Y52

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Click here

  5. REMOVE TILT AND TELESCOPIC SWITCH

    Click here

  6. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    Click here

  7. REMOVE TURN SIGNAL SWITCH

    Click here

  8. REMOVE STEERING WHEEL SWITCH HOUSING


    1. B000VTM

      Using pliers, support the band clamp while loosened.

    2. B000XJWC01
      B000WYJ Remove in this Direction
      B000WCG Protective Tape

      Using a screwdriver, detach the claw and pull the steering wheel switch housing toward the rear of the vehicle to remove it.

      Tech Tips

      Tape the screwdriver tip before use.