ILLUMINATION LIGHT ASSEMBLY(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door outside handle sub-assembly (illumination light assembly) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative(-) battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE NO. 2 DECK BOARD

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    B000W7Y

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B000Y52

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE FRONT DOOR INSIDE PANEL SUB-ASSEMBLY LH

    Click here

  5. REMOVE DOOR OUTSIDE HANDLE SUB-ASSEMBLY LH (ILLUMINATION LIGHT ASSEMBLY)


    1. B000VJAC01
      B000WCG Protective Tape

      Apply protective tape to the handle and door outer panel of the door outside handle sub-assembly LH (illumination light assembly) to prevent damage.

    2. B000XNAC01
      B000XM7 Bolt
      B000TT4 Connector

      Detach the wire harness clamp and disconnect the 4 connectors.

    3. Remove the 4 bolts and door outside handle sub-assembly LH (illumination light assembly).