REAR COMBINATION LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

    Click here

    If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE NO. 1 DECK BOARD

    Click here

  2. REMOVE NO. 2 DECK BOARD

    Click here

  3. REMOVE ROPE HOOK ASSEMBLY

    Tech Tips

    Use the same procedure to remove the rope hook assembly on the other side.


    1. B000YT6C01
      B000WYJ Open

      Detach the claw to open the 2 rope hook caps.

    2. B000TZS

      Remove the 2 bolts and 2 rope hook assemblies.

  4. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  6. REMOVE SIDE TRIM BOX

    Click here

  7. REMOVE LUGGAGE COMPARTMENT TRIM BOX

    Click here

  8. REMOVE REAR FLOOR FINISH PLATE

    Click here

  9. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH


    1. B000X0G

      Remove the 3 clips.

    2. B000X0K

      Remove the back side of the luggage compartment trim inner cover LH.

  10. REMOVE REAR BUMPER ASSEMBLY

    Click here

  11. REMOVE REAR BUMPER CORNER EXTENSION LH

    Click here

  12. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    1. B000YDN

      Disconnect the connector.

    2. Remove the nut.

    3. Remove the 8 bolts.

      B000YKW

    4. Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and clip to remove it.

      Note

      Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.

      B000Z1FC01
      B000WCN Place Hands Here B000WYJ Remove in this Direction
    5. B000UGWC01
      B000WYJ Pull Out

      Disconnect the grommet and pull out the wire harness.