WASHER LEVEL WARNING SWITCH INSTALLATION

PROCEDURE


  1. INSTALL LEVEL WARNING SWITCH ASSEMBLY


    1. B000X3LC01
      *a Protrusion
      *b Mark-off Line
      B000WYJ Install in this Direction

      Install the level warning switch assembly as shown in the illustration.

      Note

      Make sure that the protrusion comes within the range of the mark-off lines.

    2. B000WY2

      Connect the connector.

  2. ADD WINDSHIELD WASHER FLUID

    Click here

  3. INSTALL FRONT FENDER LINER LH

    Click here

  4. INSTALL ENGINE SIDE COVER LH

    Click here

  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  6. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  8. INSTALL FRONT WHEEL LH

    Click here