OUTER REAR VIEW MIRROR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Fully close the front door glass sub-assembly.

PROCEDURE


  1. REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Driver Side)

    Click here

  2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Driver Side)

    Click here

  3. REMOVE FRONT DOOR ASSIST GRIP ASSEMBLY RH (for Front Passenger Side)

    Click here

  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (for Front Passenger Side)

    Click here

  5. REMOVE NO. 1 SPEAKER ASSEMBLY WITH BOX

    Click here

  6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. B000YGSC01
      B000WYJ Open

      Detach the claw and open the wire harness protector.

    2. Disconnect the connector.

    3. B000VV4

      Detach the clamp.

    4. Open the front door glass sub-assembly LH fully open position.


      1. B000YU0

        Connect the No. 2 front door wire LH connector.

      2. B000W32C01
        B000WYJ Temporarily Set in this Direction

        Insert the upper portion of the front door trim board sub-assembly LH into the front door panel to temporarily set it.

      3. Turn the engine switch on (IG).

      4. Operate the multiplex network master switch assembly and set the front door glass sub-assembly LH to the fully open position.

      5. Turn the engine switch off.

      6. B000YU0

        Disconnect the No. 2 front door wire LH connector.

      7. B000W2QC01
        B000WYJ Remove in this Direction

        Remove the front door trim board sub-assembly LH.

    5. B000XDV

      Remove the 3 hole plugs.

    6. B000WQN

      Remove the 3 nuts.

      Note

      Hold the outer rear view mirror assembly with one hand so that it does not drop.

    7. Detach the claw and remove the outer rear view mirror assembly LH.