FUEL LID OPENER SWITCH INSPECTION

PROCEDURE


  1. INSPECT FUEL LID OPENER SWITCH (NO. 3 COMBINATION SWITCH ASSEMBLY) (for LHD)


    1. Remove the fuel lid opener switch (No. 3 combination switch assembly).

      Click here

    2. B000XJOC03
      *a

      Component without harness connected

      (Fuel Lid Opener Switch (No. 3 Combination Switch Assembly))

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6(B) - 16(L) Fuel Lid Opener Switch OFF 10 kΩ or higher
        Fuel Lid Opener Switch ON Below 1 Ω

        If the result is not as specified, replace the fuel lid opener switch (No. 3 combination switch assembly).

    3. Check that the switch illuminates.


      1. Apply battery voltage to the No. 3 combination switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 7 (ILL+)

        Battery negative (-) → 12 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the fuel lid opener switch (No. 3 combination switch assembly).

    4. Install the fuel lid opener switch (No. 3 combination switch assembly).

      Click here

  2. INSPECT FUEL LID OPENER SWITCH (NO. 3 COMBINATION SWITCH ASSEMBLY) (for RHD)


    1. Remove the fuel lid opener switch (No. 3 combination switch assembly).

      Click here

    2. B000WKRC01
      *a

      Component without harness connected

      (Fuel Lid Opener Switch (No. 3 Combination Switch Assembly))

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3(B) - 13(L) Fuel Lid Opener Switch OFF 10 kΩ or higher
        Fuel Lid Opener Switch ON Below 1 Ω

        If the result is not as specified, replace the fuel lid opener switch (No. 3 combination switch assembly).

    3. Check that the switch illuminates.


      1. Apply battery voltage to the No. 3 combination switch assembly and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 7 (ILL+)

        Battery negative (-) → 12 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the fuel lid opener switch (No. 3 combination switch assembly).

    4. Install the fuel lid opener switch (No. 3 combination switch assembly).

      Click here