OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR LH


    1. Push down the upper part of the mirror surface and tilt it.

    2. B000VIAC01
      B000WYJ Push Down
      B000WCG Protective Tape

      Apply protective tape as shown in the illustration.

    3. Using moulding remover D, detach the claw.

      Note

      Do not forcibly pull on the outer mirror LH as the unit drive may detach, or the mirror surface part may break.

    4. Push down the lower part of the mirror surface and tilt it.

      Tech Tips

      The claw will reattach if excessive force is applied when pushing down the mirror surface.

    5. B000VNRC01
      B000WYJ Push Up
      B000WCG Protective Tape

      Apply protective tape as shown in the illustration.

    6. Using moulding remover D, detach the claw.

      Note

      Do not forcibly pull on the outer mirror LH as the unit drive may detach, or the mirror surface part may break.

    7. B000WDV

      Detach the clamp.

    8. Disconnect the 2 mirror heater connectors.

    9. B000U8Q

      Detach the clamp.

    10. Disconnect the EC mirror connector.

      Note


      • Do not raise the claw higher than is necessary as it will damage the claw of the connector.

      • If the claw of the connector is damaged, replace the outer mirror LH with a new one.

      • If there is damage to the wire harness or an open circuit has occurred, replace the outer mirror actuator assembly LH with a new one.

    11. B000WRF

      w/ Blind Spot Monitor System:


      1. Detach the clamp.

      2. Disconnect the blind spot monitor indicator connector to remove the outer mirror LH.

        Note


        • Do not raise the claw higher than is necessary as it will damage the claw of the connector.

        • If the claw of the connector is damaged, replace the outer mirror actuator assembly LH with a new one.

        • If there is damage to the wire harness or an open circuit has occurred, replace the outer mirror actuator assembly LH with a new one.