FLUSH HANDLE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Main Body, Front Left Door or Front Right Door / Data List.

    6. According to the display on the GTS, read the Data List.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Outside Door Handle Fold Adjust Setting to adjust the sensitivity (speed) that determines when the door outside handle sub-assemblies retract according to vehicle speed Level1(Low), Level2, Level3 or Level4(High) Current customize setting displayed -
      Outside Door Handle Fold Waiting Time Setting of retraction time for automatic door outside handle sub-assemblies when the following operations are not performed* 60sec or 20min Current customize setting displayed -

      • *: If the "Outside Door Handle Fold Waiting Time" setting is set at "20min", the door outside handle sub-assemblies will retract when the engine switch is on (IG), the doors are unlocked and the vehicle is left for 20 minutes.


      Body Electrical > Front Left Door > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Flash Handle Position Switch Displays the position of the door outside handle sub-assembly LH Fold or Return

      Fold: Door outside handle sub-assembly LH retracted (open position detection switch off)

      Return: Door outside handle sub-assembly LH opened (open position detection switch on)

      		 -

      Body Electrical > Front Right Door > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Flash Handle Position Switch Displays the position of the door outside handle sub-assembly RH Fold or Return

      Fold: Door outside handle sub-assembly RH retracted (open position detection switch off)

      Return: Door outside handle sub-assembly RH opened (open position detection switch on)

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Front Left Door or Front Right Door / Active Test.

    6. According to the display on GTS perform the "Active Test".


      Body Electrical > Front Left Door > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Flash Handle Return Opens door outside handle sub-assembly LH Return or OFF -
      Flash Handle Fold Retracts door outside handle sub-assembly LH Fold or OFF -

      Body Electrical > Front Right Door > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Flash Handle Return Opens door outside handle sub-assembly RH Return or OFF -
      Flash Handle Fold Retracts door outside handle sub-assembly RH Fold or OFF -