QUARTER WINDOW GLASS REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, initialization or registration) that must be performed after parts are removed, installed or replaced during the quarter window glass assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point LKA/LDA system

Click here

Pre-collision system
Parking assist monitor system

Click here

Steering sensor zero point calibration Variable gear ratio steering system

Click here

Front seat assembly RH (Only for removal and installation) Initialize position control ECU Front Power Seat Control System

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE UPPER QUARTER WINDOW MOULDING LH

    Click here

  3. REMOVE ROOF SIDE RAIL GARNISH SUB-ASSEMBLY LH

    Click here

  4. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  5. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  6. REMOVE REAR SEAT SIDE GARNISH

    Click here

  7. REMOVE REAR SEATBACK COVER

    Click here

  8. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  9. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  11. REMOVE QUARTER INSIDE TRIM BOARD LH

    Click here

  12. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

    Click here

  13. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  15. REMOVE QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  16. REMOVE CENTER PILLAR GARNISH ASSEMBLY LH

    Click here

  17. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  18. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  19. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  20. REMOVE QUARTER WINDOW ASSEMBLY LH

    Note

    The quarter window assembly LH may fall while performing this procedure. Therefore, use suction cups to hold the quarter window assembly LH from the outside of the vehicle.


    1. B000XQ5

      Disconnect the connector.

    2. B000X40C01
      B000WCG Protective Tape

      Apply protective tape to the area around the installation position of the quarter window assembly LH on the vehicle body to prevent it from being scratched.

    3. Install the suction cups to the quarter window assembly LH.

    4. B000X56C01
      *a Piano Wire
      *b Clip

      Pass a piano wire between the vehicle body and quarter window assembly LH from the interior.

    5. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

    6. Cut off the adhesive by pulling the piano wire around the quarter window assembly LH.

      Note

      When separating the quarter window assembly LH, be careful not to damage the paint or interior and exterior ornaments.

    7. B000U30

      Using suction cups, disconnect the clip and remove the quarter window assembly LH.

      Note


      • Do not to drop the quarter window assembly LH.

      • Be sure to replace the quarter window assembly LH with a new one.