BACK WINDOW GLASS INSPECTION

PROCEDURE


  1. INSPECT NO. 1 REAR WINDOW WIRE


    1. B000VKFC02
      *a

      Component without harness connected

      (No. 1 rear window wire)
      *b

      Component without harness connected

      (No. 1 rear window wire(Vehicle connection side connector))
      *c

      Component without harness connected

      (No. 1 rear window wire(Rear window defogger connector))
      *d

      Component without harness connected

      (No. 1 rear window wire(Glass brekage sensor connector))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A1 - B1 Always Below 1Ω
      A2 - C1 (SSR-) Always Below 1Ω
      A4 - C2 (SSR+) Always Below 1Ω

      If the result is not as specified, replace the No. 1 rear window wire.