ION GENERATOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL ION GENERATOR SUB-ASSEMBLY


    1. B000YAZC01
      *a Guide
      *b Claw
      B000WYJ Align with the guide position and insert in a straight line

      Align the guide, attach the claw and install the ion generator air duct sub-assembly as shown in the illustration.

    2. B000UAG

      Connect the connector.

    3. B000WL8C01
      B000WYJ Insert in this Direction

      Insert the ion generator with air duct sub-assembly in the direction of the arrow shown in the illustration and insert the No. 3 heater to register duct sub-assembly as shown in the illustration.

    4. B000UTJ

      Set the guide and install the ion generator with the air duct sub-assembly with the 2 screws.

  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. INSTALL NO. 2 GLOVE COMPARTMENT PANEL

    Click here

  6. INSTALL FRONT DOOR NO. 2 OPENING TRIM COVER RH

    Click here

  7. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

    Click here

  8. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

    Click here

  9. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

  11. INSTALL NO. 2 DECK BOARD

    Click here

  12. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  13. INSPECT SRS WARNING LIGHT

    Click here